Grease trap installation

How do you install a grease trap?

Grease trap installation may look simple enough, but there are numerous factors you must consider before beginning. Many people think they can save money by doing it themselves, but this often leads to costly mistakes and a less than ideal installation. When grease begins collecting under your sink, floor commercial drain cleaning or behind your hot water heater, you’re in trouble. Hiring a professional commercial brand interceptor, high quality commercial brand traps or grease trap liners can prevent costly damage to your plumbing system, reduce the chance of leaks or further damage and extend the life of your grease trap.

Steps to follow in grease trap installation that should be followed by any professional plumber or licensed electrician who is hired for this job. If you’re doing the work yourself, be sure to use gloves, old-fashioned goggles and protection for your eyes and ears. You must also wear a respirator or safety mask at all times. In no circumstance should you use a breathing mask near a hot water heater, gas heater or any other source of heat or flame.

What are requirements for grease traps?

After installing new grease trapDon’t begin your grease trap installation during the middle of the cooking cycle. Your water may already be heating up by then and you could cause a serious plumbing or electrical problem. Keep the heating element on and wait until your water is cool before you open the trap. If you don’t know when your water is going to be finished heating up, set your thermostat to the desired temperature before you open the trap.

It is extremely dangerous to mix chemicals with cooking fluids. Never pour both commercial grease cleaning products and oil into the trap. Mixing the chemicals is just asking for a serious accident. If you must mix the two together, stir it very carefully to disperse the ingredients. Do not open the trap during the cooking process; wait until you are nearly done with the cooking process and then open the trap to release the cooked-out mess.

Why you shouldn’t do your own plumbing?

When plumbing or electrical repairs are involved, never try to take the unit apart yourself. This is a recipe for disaster. If you have any question about the plumbing job, ask for professional assistance from licensed contractors in your area. If you attempt to take apart a faulty trap during the repair process, you will cause damage to the plumbing. The last thing that you need is someone accidentally nicking the trap interceptor, causing more damage.

If high pressure cooking is a regular occurrence, you will occasionally have to clean grease traps by replacing them. High pressure fogs can be cleaned by simply putting them in a high traffic spot like the garbage disposal. You can also use high pressure washers to clean the fogs. In fact, high heat cleaning will often clear out high level fogs.

When sewer line maintenance is needed, call your local plumber or sewer cleaning company for assistance. Not only will your service company know how to remove a clogged sewer line, they will also know how to prevent future occurrences. If you discover a high pressure trap in your residential area, contact a commercial plumbing company in your area. They will be able to advise you on the best solution for your particular situation.